|
概述 GENERAL DESCRIPTIONS：
本機組是一種可以同時完成干燥和造粒的裝置，按工藝要求可以調節料液泵的壓力、流量、噴孔的大小，得到所需的按一定大小比例的球形顆粒。
本機組工作過程為料液通過隔膜高壓輸入，噴出霧狀液滴，然后同熱空氣并流下降，大部分粉粒由塔底排料口收集，廢氣及其微小粉末經旋風分離器分離，廢氣由抽風機排出，粉末由設在旋風分離器下端的收粉筒收集，風機出口處還可以裝備二級除塵裝置，回收率在96-98%以上。本機組與物料接觸部分的塔體、管道、分離器的材料，均采用SUS304制作，在塔體內部與外殼之間有足夠的保溫層，塔體設有觀察門、視鏡、光源及控制儀表，由電器控制操作臺控制和顯示。
本機組的熱源裝置采用蒸汽加熱或電加熱器，具有操作方便、啟動快、結構緊湊、熱風干凈清潔等優點。另外在電氣控制柜內裝有電加熱器的控制調節裝置，使進口溫度無級調節。對于缺電地區可采用蒸氣加熱、燃煤或燃油熱風爐等方式，局部或全部代替電加熱裝置。本廠可以根據用戶的實際需要提供不同的加熱方式。
The set is an apparatus that can finish drying and granulating at the same time. The needed ball granule with requirements of process to adjust prtssure, flow, and size of atomizing hole.
The working process of set is as follows; the liquid of raw material is pumped in through diaphragm pump. The liquid of raw material atomizes into tiny droplets. Then it gathers with hot air and fall off. Most parts of powder material will be collected through the outlet of discharge at the bottom. The wasted air and fine power will be separated through cyclone. The wasted air will be exhausted through draught fan and power will be collect through collected through collector at the bottom of cyclone. At the outlet it can also be equipped with two grades of duster. It radio of recovery will be over96～98%.
The tower body,pipes,separator of set where will contact with raw material are made of SUS304. There is enough layer of heat preservation between inner and outer case of tower body.The filled.material is fine glass cotton, The tower body is also equipped with abservation door, sight glass, lamp-house and control meters and instruments that is controlled and displayed through electric control meters and instruments that is controlled and displayed through electric control panel.
The heat source of set may be steam or electric heater.Its features are convenient in opration,quick in start, compact,clean hot air and so on.Moreover being installed control and regulating device inside electric control cabinet,the inlet temperature can be controlled through stepless regulation.The steam,coal fuel or oil fuel can be applied to the place where has not electicity. It can replace electric heating partially or fully.The factory can provide different heating way in accordance with the practical condition of cuctomer.
設備特點 FEATURES OF EQUIPMENT：
- 干燥速度快，料液經霧化后表面積大大增加，在熱風氣流中，瞬間就可蒸發95%-98%的水份，完成干燥的時間僅需十幾秒到數十秒鐘，特別適用于熱敏性物料的干燥。
- 所得產品為球狀顆粒，粒度均勻，流動性好，溶解性好，產品純度高，質量好。
- 使用范圍廣，根據物料的特性，可以用熱風干燥，也可以用冷風造粒，對物料的適應性強。
- 操作簡單穩定，控制方便，容易實現自動化作業。
- The dry speed is fast. The surface area of raw material liquid after being atomized will be increased greatly.95-98% of moisture can beevaporated at moment. The time to finish dry needs about ten seconds to several tens of seconds. It is suitable for drying thermal sensitive material particularly.
- The finished product is ball granule with uniform size. Its fluidity and solubility are good. The purity of product is high and its quality is good.
- It scope of application is wide. According to the characteristics of raw material, it can use hot air to dry and can also use cool air to granulate. It has strong adaptability to raw materials.
- Its operation is simple and stable and its control is simple and convenient and is easy to realize automatic operation.
適用范圍 SCOPE OF APPLICATION：
噴霧干燥造粒：
| 
